Welder Calibration

All Counties Covered If you have BS or ISO quality standard procedures in place or are working towards CE accreditation it is likely that your procedures will require annual calibration of your welding equipment. We can provide a calibration service to IEC60974-14 which is the recognised standard for calibration/recalibration of arc/Mig welding power sources. IEC60974-14  is a nationally recognised standard and all our test is equipment is calibrated to NAMAS standards, with full traceability. What can be calibrated? Any welding power source including Mig, Tig, MMA, Submerged Arc that is fitted with Amp and Volt meter, provided that the meters function correctly and are undamaged. Any welding power source that has controls marked with scales indicating Amps and/or Volts. This is called 'Validation' but still results in a valid certificate if successful. However, we recommend fitting a new digital meter kit to such machines to provide a full calibration and so the welder can follow the meter readouts when performing specific weld procedures. My equipment has no meters and no scales marked Equipment with no meters/scales cannot be calibrated as is - however, we can fit a digital meter kit to almost any machine. Our digital meter kits are installed by our engineer and then trimmed & calibrated to suit that specific machine on site resulting in minimal downtime. Once the digital meter kit has been fitted, trimmed & calibrated, you will receive a calibration certificate valid for one year as normal. The kit takes our engineer about 1 hour to fit and can be located anywhere suitable on the machine.